If necessary use the viewcube to spin the design to facilitate selecting the wall or roof edges.
Revit wall from roof to roof.
In the drawing area highlight an entry wall.
On the options bar for overhang enter 600 and select defines slope.
When a dashed line is displayed on the exterior of the wall press tab to select the chain of walls and click to place the roof lines.
If i delete the roof or modify it it deletes the attached wall.
Select an edge of the roof that you want to join and then select the wall or roof to which you want to join the roof.
Create a sloped roof with an overhang.
To unjoin roofs click modify tab geometry panel join unjoin roof.
This is a general.
Hello i m relatively new to revit and this forum and i hope i m doing this right.
You can join roofs to other roofs or walls or unjoin them if they were previously joined.
On the draw panel click pick walls.
But i want it to end at the roof where i painted the red line.
My problem ist that when i make a section the outer wall goes into the roof.
I have tried selecting and then using the detach icon and the detach walls in the properties is ticked but greyed out and won t allow any changes.
Place the 3 walls in the plan view.
On the properties palette set the top constraint for the walls to unconnected and specify a height of 4000.
Confused by revit roofs.
The wall must be attached to the target roof and the target roof must be a footprint roof.
Being able to detach the wall from the roof.
You cannot join a roof to more than one top face of another roof.
You can join a roof to the top face of another roof and the wall below that roof if you select the wall as the target.
Check out the complete blog post.
I hope my problem is clear when you look at the screenshot.
Http pbl stanford edu how to attach walls to roof objects in revit.
Click modify tab geometry panel join unjoin roof.
Thanks for the help 39377.
Next the walls need to be moved to the roof line to create the dormer.
I have attached a number of walls to a flat roof.