Replacing Laminate Boars

Laminate flooring uses a glueless and nail free system.

Replacing laminate boars.

That means that it s easy to replace small portions of flooring when necessary. Discard the boards that are damaged. Both tile and laminate flooring planks can be installed over wood or concrete subfloors. Now it comes time for the replacement laminate plank.

You can fix minor chips and scratches in a laminate floor with filler products. Laminate floor buckling like lifting can be caused by changes in temperature and humidity levels. Then use a rubber mallet to tap the two boards together. Place a board right up against one of the boards that are still on the floor and join them together at the laminate joint.

Sometimes putty and wax is not enough. Step 3 install the new laminate. Use a hammer and chisel or putty knife to remove baseboards or molding near the damaged boards. Laminate floors are a boon for homeowners who want the look of a wood floor without the hefty price tag.

How to replace an interlocking laminate board. One is to disassemble the floor down to the damaged board replace the board and reassemble. It s a job you can do yourself in about two hours. The best tool to do it will be a vibratory undercut saw.

Replace the scratched boards. But if the damage is severe you have to replace the plank you did save a few from the installation right. Since you must level either type of subfloor before laying tile if you decide that you want to replace a tile floor with laminate flooring you won t need to do as much work to make sure the floor sits level. If your scratches are too deep or you have several of them on one plank you might need to replace the damaged boards.

Tile will last forever under normal conditions but carpet and laminate may need replacement in ten years or less. Hardwood properly maintained can last for decades but it may require more. The repair process is basically the same. You have to cut off the tongue on both sides the short and long edge of the board.

Take some of the new boards and install them in the area where you took up the old laminate. Laminate flooring brands may also require trimming of the groove along a short edge so the new plank will sit in place.