Removing Carpet Nail Strips

Locate the brad nails that hold the first piece of tack strip to the floor.

Removing carpet nail strips.

After pulling up your carpet you will most likely have tack strips left around the perimeter of the room. Removing tackless strips is a job requiring a certain amount of patience and care if you do not intend on refinishing the floor. Carpet tack strips can usually remain in place but look for rust rot or other damage. Removing old carpeting may be necessary to save labor costs if you are having your carpet replaced.

The strips of metal nails under your carpet and carpet padding are called tack strips. Typically there will be three nails spaced evenly along each three foot section of tack strip. Some people have a hard time with this step but i ll show you how to remove carpet tack strips the easy way with three simple tools. Begin at the top of the stairs.

A very easy way to remove carpet tack strip from the basement concrete floor. Carpet tack strips are pieces of wood with small sharp nails sticking out of them that grip a carpet and hold it in place. Step 3 place the curved edge of a small pry bar against the tack strip lining the pry bar up with the first nail. Pick somewhere to start either a corner or a break between two tack strips.

Grab the cut end of carpet and pull it from the stairs using gloved hands. You may also need to remove your carpet if you have hardwood floors underneath that you would like to refinish. Step 5 remove the carpet tack strips. Its not that hard with these tips from clay king from aaa flood drying with 28.

Use the 6 in 1 painter s tool and a hammer to lift one end of one of the strips. If you re removing your old carpet and planning to install new carpet in its place you don t have to remove. Pry up the metal nosing and remove it if present. Carpet tack strips are wooden boards installed around the perimeter of a floor to hold carpet in place.

If you decide to remove the carpet you must also pry up the tack strips which are held in place with nails. The trick is to use a cat s paw prybar and to remove all the nails holding each tackless strip. If not cut the carpet near the top of the top stair riser.