Remove Standing Water From Crawl Space

How do you remove moisture from your crawl space caused by cold water pipes.

Remove standing water from crawl space.

It can be difficult to insulate cold water pipes under your house. Look for signs of standing puddling water on the ground and signs of the discoloration caused by mildew and wood rot on the wooden posts piers and overhead structural members of the house. But if there are significant puddles or multiple low areas use one or more portable sump pumps to remove that standing water. Extract the water utilize a pump to remove the standing water from the crawl space.

If you have a sump pump in the crawl space make sure it s working. If the crawl space floor were flat and drained to one single low point just one sump pump would usually be enough. How to prevent flooding and remove water in a crawl space. Use a wet vac to remove water left behind after pumping.

Remove the vapor barrier if your crawl space already has a plastic vapor barrier it should be removed rolled up and removed through the access door. How to remove standing water and dry a crawl space. Make sure the hoses are correctly attached to the pump so the water is pushed away from the house. Place the pump in the impromptu moat and use the pump there.

While a professional is probably the better option in the case of large amounts of standing water you ll want to remove any vapor barrier which has been placed and dig a three to four inch trench around the outside of the crawlspace. Stop the flow of water if water is still entering the crawl space stop the flow immediately and repair any leaks. Use a wet dry vaccum to remove standing water. Invest in a wet dry vacuum.

Then insulate cold water pipes to prevent condensation. Don t allow your crawl space to air dry after this step. Install a french drain along the perimeter of the crawl space with sump pumps install sand in low lying areas not effective to stop flooding in a whole crawl space install gutters with downspout extensions. The insulation will ensure that any condensation occurring will not impact the air around it.

Even if it is operating properly back it up with another pump to move out standing water as quickly as possible. Finish with a wet vacuum.